CONFIGURATION AND CALIBRATION – Software Calib.
Page 65 of 80
When communication is established, the word CONNECTED appears in a
gray stripe at the bottom of a new Setup window containing the current
data from the controller.
Values
immediately to the
right of the
parameter names
are the current of
operational values
in the DSC. The
Data Entry Blocks
are where you
enter new
parameter values.
Clicking the SET
button puts the
values into effect,
and moves the
values from the
Data Entry Blocks
to the current
value side, but
new settings are not permanent until DSC SAVE is selected from the File
menu. The RESET button restores the Data Entry Blocks to the last Set
values (the values just to the right of the parameter names).
NOTE:
Once calibration data has been entered in each Property Sheet, click the
SET button before closing the Property Sheet.
Rudder Feedback Calibration Window
This procedure calibrates the
rudder feedback signals by
informing the DSC what signal
levels to expect from the
feedback unit for midships, hard
port and hard starboard rudder
positions.
SET will transfer the values in
the right column to the DSC.
The ORIGINAL button will
restore the last set values to the
right column. DEFAULT will set
Doc No.: MAN01504, 20-02-06 DSC 100 & MCP 100 Manual
To Next Page
Loading...