JAWA B - Pivoted Fork

57
Fig. 40 Pivoted rear fork bushing - sectional view
1. Pivoted rear fork 7. Fork pin
2. Bush 8. Nut
3. Rubber seal 9. Locking bolt with nut Lubricating Pipe
4. Bolt 11. Screw M8X55
5 Thrust washer
6. Cup
17. PIVOTED REAR FORK
Before removing the pivoted rear fork the following operations have to be carried
out:
Remove the cowls (para 15), the suspension dampers (para 16), The rear wheel
(pars 2), chaincase (para 3) and the rear chain (para 4),. and exhaust silencers.
After removing these parts unscrew the bolt and nut on the tube bottom and the
two nuts (17) on the L. H. side of the frame. Push the released bolt out to the R.
H. side and remove the thrust washer. Using a puller pull out the fork pin. It is
recommended to have this repair done in a specialist workshop equipped with
special tools.