INTRODUCTION
Jays Audio products are built with performance and durability in mind. Each product
is tested carefully with Audio Precision APX525 before shipping. Careful installation of
the product will ensure the correct performance and ensure the product is at its full
potential.
PACKAGE CONTENTS
1. CDT3-MK3
2. AC Mains Power Cord
3. Disc Clamp
4. Gloves
5. Remote Control Unit (without batteries)
6. Spare Fuse
UNPACKING
The CDT is shipped with sturdy double boxes. Please keep the box should you need
to transport the unit to another location.
Carefully unpackage the CDT, place it on a stable surface, i.e. HiFi Rack. You may wish
to use the gloves provided while handling the CDT.
Peel off the transparent green tape of which was used to factory sealed the top
loading slider lid.
Slide open the top loading lid, located the protective foams inside. The protective
foams were intentionally stuck in between the CDPRO2 laser assembly space to
prevent the potentially erratic movement of the laser during transit. Remove the
protective foams completely.
To Next Page
Loading...