JAY CU SHIONS
B. EASY MAINTENANCE AND CLEANING
Monthly cleaning and regular maintenance may help extend the life of
your cushion. Before, during, and after cleaning, component inspec-
tion is recommended.
Check the cover for tears and excessive wear and or any other
abnormalities.
Check the foam base to ensure foam consistency. While checking
the fluid pad if you ever feel the fluid is firmer in one area, simply
knead the fluid back to its original consistency and/or call your local
authorized supplier.
Cleaning the cover:
1. Remove the cover from the foam base and turn inside out.
2. Next turn inside out the inner pocket that contains the fluid pad.
(Note that the foam insert cushion option will not have a pocket
in the cover.)
3. Remove the fluid pad from the inner pocket by pulling on it,
disengaging the Velcro
®
material.
4. Turn the inner pocket right side out and zip the cover halfway
closed. (The cover is zipped halfway closed to keep the Velcro
®
material from snagging on any other items in the wash.)
5. Machine wash in warm water and drip or tumble dry on low heat.
NOTE: Do Not iron the cover, excessive heat could damage it.
NOTE: Do not dry clean covers or use industrial washers and
dryers to clean the cover. Do not steam autoclave. Do not bleach.
Use only Jay-designed covers on Jay fluid cushions.
Cleaning the foam base:
1. Remove the cover and fluid pad from the foam base. Wipe lightly
with a damp cloth. Do not use soap. Wipe off with a clean cloth.
Let it completely air-dry before reassembly.
NOTE: Avoid submersion of the foam base in water.
Reinstall the cover with the fluid pad cover back over foam base.
Ensure the back of the cover matches up to the back of the foam
base.
For goods provided by Sunrise Medical Pty Ltd in Australia, our
goods come with a guarantee by Sunrise that cannot be excluded
under the Australian Consumer Law. You are entitled to replace-
ment or refund for a major failure and for compensation for any
other reasonable foreseeable loss or damage. You are also entitled
to have the goods repaired or replaced if the goods fail to be of
acceptable quality and the failure does not amount to a major
failure. The benefits to you given by this warranty are in addition
to your other rights and remedies under a law in relation to the
goods to which the warranty relates.
SUNRISE LIMITED WARRANTY
USE AND MAINTENANCE
Laundry Care Symbols
Machine wash in warm water
60° C
Only non-chlorine bleach,
when needed
Drip Dry
Do not Iron
Do not dry clean
To clean fluid pad:
Remove the cover from the foam base. Remove fluid pad from its
inner pocket and wipe with warm water and soap. Rinse with a
clean, damp cloth. Then wipe dry with a clean cloth.
Never submerge the fluid pad in any liquid.
Reassembling the cushion after cleaning:
Follow cleaning and maintenance instructions as described in “Easy
maintenance and cleaning” then reassemble as follows.
Insert the Jay Flow Fluid pad in its inner pocket in the moisture
resistance cover matching all eight Velcro
®
strip locations. Insert
the foam base into the outer cover. Ensure that the zipper is at
the rear of the foam base (the part number tag should be to the
rear of the foam base) where the seat well is located.
ADDENDUM TO WARRANTY USE AND CARE GUIDE
For Jay Products Containing JF35 Fluid
Consult your healthcare professional for proper fitting and use, and
read the following statements carefully:
• The fluid in this cushion may lose volume over time.
• Volume loss in this cushion may result in bottoming out the
cushion.
• Monthly, during routine cleaning and inspection, check this
cushion for bottoming out (see instructions under “checking for
bottoming out” in the warranty use and care guide) and any fluid
inconsistencies, If the fluid is firmer in one area simply knead it
back to its original consistency.
• If bottoming out occurs discontinue use of this cushion and
contact your healthcare professional. If further assistance is
necessary, con-tact your Sunrise Medical Customer Service at
1-800-333-4000.
JAY EASY CUSHION WARRANTY
Each Jay fluid cushion is carefully inspected and tested to provide
peak performance. Every Jay fluid cushion is guaranteed to be free
from defects in materials and workmanship for a period of 24
months from the date of purchase, provided normal use. Should a
defect in materials or workmanship occur within 24 months from
the original date of purchase, Sunrise Medical will, at its option,
repair or replace it without charge. This warranty does not apply
to punctures, tears or burns, nor to the cushion’s removable
cover.
Claims and repairs should be processed through the nearest
authorized supplier. Except for express warranties made herein, all
other warranties, including implied warranties of merchantability
and warranties of fitness for a particular purpose are excluded.
There are not warranties which extend beyond the description on
the face hereof. Remedies for breach of express warranties herein
are limited to repair or replacement of the goods. In no event shall
damages for breach of any warranty include any consequential
damages or exceed the cost of non-conforming goods sold.
Record your serial number here for future reference:
____________________________________________
XTJE Rev. E
To Next Page
Loading...
