SECTION 9
TOWABLE SLIDEOUT SYSTEM
The following decal should remain
permanently affixed to your RV. If you have
any questions regarding the rear wall slideout
system please contact your dealer or our
customer service department.
Fig. 9.5 Rear bed slideout label
M-Tec sofa slideout override
In the event of a power failure or low battery,
the slide-out room may be operated manually
with a 5/8” ratchet wrench (not supplied). The
manual crank shaft is located on the motor-
transmission housing. Turn the crank
clockwise to move the room “in”, counter-
clockwise to move the room “out”.
9 - 3
To Next Page
Loading...
