SECTION 8-PLUMBING SYSTEMS JAYCO TOWABLE
2. Follow the directions on your (RV approved) toilet chemical bottle (customer
supplied), by placing the recommended quantity of holding tank chemical into the
toilet bowl.
3. Flush the toilet and allow at least two gallons (8 liters) of water to flow into the
holding tank.
Waste (grey) holding tank preparation:
No special preparation is required, however, placing a small quantity of chemicals into this
tank, such as baking soda or an approved RV chemical, will reduce odors from food
particles in the system.
Cleaning & Maintenance:
The toilet should be cleaned regularly for maximum sanitation and operational efficiency.
Use only RV approved chemicals. Do not use chlorine (undiluted) or caustic chemicals,
such as laundry bleach or drain opening types, in the toilet system. These products damage
the seals in toilets and dump valves.
BLACK TANK FLUSH (RINSING THE WASTE TANK)
The Tank Flush Inlet (also known as the No Fuss Flush), is the black inlet located on the
Utility Center Panel. This inlet is provided to assist in flushing out the black water tank.
The dump valve for the black water tank must be OPEN to use this feature.
When a water hose is connected, and when the water source is turned on, it sprays water
into the black water tank, which aids in moving out the waste and cleaning the interior of
the tank.
NOTE: The colored valve positions do not affect the Tank Flush function. It does not
matter where they are positioned when operating the Tank Flush. Refer to the Uni-Dock
Utility Center
Sewer Tank Flush Inlet procedure:
1. Connect the flexible sewer hose to the 4 inch dump outlet under the recreation
vehicle.
2. Open the black water dump valve on the utility center and leave it open. Allow the
tank to drain.
3. Attach a water hose to the tank flush inlet. Do not use your fresh water hose for this.
To Next Page
Loading...
