4. Attach the other end of the hose to a pressurized water source (40 PSI minimum).
5. Turn the pressurized water source ON. Flush the tank until water appears clear in the
4 inch sewer hose. (Dump valve must remain open)
6. Turn the water source OFF. Disconnect the hose from the water source.
7. Disconnect the hose from the tank flush inlet on the utility center.
8. Disconnect the sewer hose, and close the dump valve.
NOTE: To keep debris from clogging the tank sprayer orifices, use the tank flush
every time the waste tank is emptied.
TOILET
The toilet is efficient and easy to operate. Generally, more water is required only when
flushing solids. Prior to using the sanitation system, it is strongly recommended to flush
the toilet several times to release sufficient water into the holding tank. If there is not a
sufficient amount of water used during flushing, the waste materials may not evacuate
properly from the drain line to the tank. Clogged tanks and pipes could eventually occur.
The toilet system will perform better when water is run for ten to fifteen seconds after
flushing to ensure that the waste will proceed to the bottom of the tank.
Unlike a toilet in a home, which may use up to seven gallons of water per flush, the
average recreation vehicle system uses one to three quarts (1 - 3 liters).
For added convenience and better sanitation system performance, it is advisable to always
have four to six inches (10 - 15 cm) of water in the toilet.
Sewage (black) tank preparation
1. Release one to two quarts (1 or 2 liters) of water into the toilet bowl.
2. Follow the directions on your (approved RV) toilet chemical bottle (customer
supplied), by placing the recommended quantity of holding tank chemical into the
toilet bowl.
3. Flush the toilet and allow at least two gallons (8 liters) of water to flow into the
holding tank.
To Next Page
Loading...
