EasyManua.ls Logo

Jayco 2016 White Hawk - Cleaning the Exterior; Washer;Dryer Prep

Jayco 2016 White Hawk
150 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SECTION 10 APPLIANCES JAYCO TOWABLE TABLE OF CONTENTS
WHTT 10-8
Use a vacuum cleaner with a soft brush to clean the grille, the open areas behind the
grille and the front surface area of the condenser.
Replace the base grille when finished.
Cleaning the exterior
Painted metal exteriors: wash with a clean sponge or soft cloth and a mild detergent in
warm water.
Stainless steel exteriors: wash with a clean sponge or soft cloth and a mild detergent in
warm water. Do not use appliance wax, polish, bleach, or other products containing
chlorine on stainless steel. Stainless steel can be cleaned with a commercially available
stainless steel cleaner. A spray-on stainless steel cleaner works best.
IMPORTANT: Do not allow the Stainless Steel Cleaner and Polish to come into contact
with any plastic parts such as the trim pieces, dispenser covers or door gaskets. If
unintentional contact does occur, clean plastic part with a sponge and mild detergent in
warm water. Dry thoroughly with a soft cloth.
For silver-accented plastic parts, wash with soap or other mild detergents. Wipe clean with
a sponge or damp cloth. Do not use scouring pads, powdered cleaners, bleach or cleaners
containing bleach as these products can scratch and weaken the paint finish.
WASHER/DRYER PREP (IF SO EQUIPPED)
If your recreation vehicle was built with washer/dryer prep, be aware the cabinet space
provided is intended for the installation of an aftermarket washer/dryer combo unit
(customer supplied) only. Please consult your dealer or the manufacturer for installation
assistance.
A dryer vent opening must be cut into the sidewall of the recreation vehicle if installing a
dryer. A label has been installed to assist you in placing the vent in the correct location.
The label will be located in the area where the dryer will be installed.
Dryer vent label
Look for the dryer vent label on the wall in the location where the dryer will be installed.
Instructions on how to cut the dryer vent hole and how to install the dryer vent in the wall
of the recreation vehicle are included in your warranty packet
WARNING
Gas dryers should NEVER be installed in your recreation vehicle. Dryer prep has
been designed for electric dryer operation ONLY.
CAUTION
Do not operate a dryer in the recreation vehicle unless the dryer is properly vented.

Table of Contents

Related product manuals