REFRltGERATOR (Optional
in
some
units)
The refrigerator in your Jayco has been designed by
the
manufacturer to work either on 110-volt electricity or L.P.-gas.
NEVER
attempt to connect or operate the refrigerator on natural gas.
Please follow the operating instructions supplied by the manufacturer
of the refrigerator.
If
the refrigerator
is
not level, the cooling process will be partially or
totally stopped. For best cooling, Ievel the vehicle and this should
Ievel the refrigerator. Remember it's the refrigerator that must
be
leveled, so check the freezer shelf
of
the refrigerator with a bubble
level. Installation of small levels on the outside of the trailer make
the
leveling operation easier.
HOT
WATER
HEATER
Your new coach may be equipped with either
a
6-gallon or 10-gallon
hot water heater powered by L.P.-gas.
If
hot
water is used with discretion, there
is
always an ample supply.
With controls similar to those on your home water heater, L.P.-gas is
automatically supplied to heat water to
a
desired temperature and
then automatically shut
off,
leaving the pilot burning.
A
regulated
mixture of'gas and air
is
ignited
by
the pilot to provide a flame which
is direeted into the heating tube. The heating assembly is sealed off
from
the
R.V.
interior and vented to the outside atmosphere.
If
gas
supply
to the heater is cut
off
for any reason or if
the
pilot
is
blown out, all gas supply is automatically cut off and controls will
have to be reset to obtain pilot relighting.
CAUTION:
Before
lighting
the
water
beater,
inswe
that
the
fresh
water
system
is
filled
with
water
and
the
air
is
purged
from
the water
heater
by
opening
dl
faucets
until water Rows steadily
horn
each.
LIGHTING
THE
WATER
HEATER
1.
Tarn gas dial
(1)
to
"OFF"
position.
2.
Wait
5
minutes
to
allow gas which may have accumulated in the
burner compartment to escape.
3.
Turn
gas
dial
(1)
to
pilot position.
4.
Depress
and
hold reset button
12)
whiIe lighting pilot burner.
Allow pilot to burn for
30
seconds before releasing the reset
button. If pilot does not remain
lit,
repeat operation allowing
longer period of time
for
releasing reset button.
5.
Turn gas dial
(1)
to
"ON"
position.
6.
Turn
temperature dial
(3)
to desired position.
7.
To shut down heater, turn to
"OFF"
position.
To Next Page
Loading...
Need help?
General
