67
MAINTENANCE CHECKLIST
Prior to First Trip
q Insert black plastic rods into the bottom pockets of the privacy curtains.
q Condition the tent.
q Perform first time installation for the canopy. (Canopy option only.)
q Perform first time installation for the screen room. (Screen room/deluxe
screen room options only.)
q Lubricate entrance door track.
q Check LP gas lines for leaks.
q Test LP gas detector.
q Sanitize fresh water system.
q Tighten wheel nuts to specified torque values.
q Open all windows and the door and start the furnace. Leave the windows and
door open and the furnace on until all fumes fully dissipate. (Furnace option
only.)
q Install soft storage hangers on curtain track
First Ten Miles
q Tighten wheel nuts to specified torque values.
First Twenty-Five Miles
q Tighten wheel nuts to specified torque values.
First Fifty Miles
q Tighten wheel nuts to specified torque values.
First Two-Hundred Miles
q Tighten wheel nuts to specified torque values.
q Have brakes adjusted by a qualified service technician.
Each Trip
q Test LP gas detector.
q Inspect bed bow supports.
q Check battery water level. (If equipped with battery.)
q Check brake fluid level in master cylinder reservoir. Keep filled to within ½”
from top of reservoir. (Hydraulic Brake option only.)
q Check master cylinder cap for tightness. (Hydraulic Brake option only.)
q Check tire pressure and wear.
q Check running lights.
q Inspect safety chains for signs of wear.
q Test brakes.
To Next Page
Loading...
