1. Release one to two quarts (1 or 2 liters) of
water into the toilet bowl.
2. Follow the directions on your toilet
chemical bottle (customer supplied), by
placing the recommended quantity of
holding tank chemical into the toilet bowl.
3. Flush the toilet and allow at least two
gallons (8 liters) of water to flow into the
holding tank.
Waste (grey) holding tank preparation
No special preparation is required; however,
placing a small quantity of chemicals into this
tank (such as baking soda or an approved RV
chemical) will reduce odors from food particles
in the system.
Cleaning & Maintenance
The toilet should be cleaned regularly for
maximum sanitation and operational
efficiency. Do not use chlorine (undiluted) or
caustic chemicals, such as laundry bleach or
drain opening types, in the toilet system.
These products damage the seals in toilets
and dump valves.
For more information
Refer to the OEM operator’s manual. If you
have further questions consult your RV dealer,
the OEM or Jayco Customer Service.
49
SECTION 5
PLUMBING SYSTEM
To Next Page
Loading...
