41
1. Press the power button to energize the system. LCD screen will display JACKS
DOWN.
2. Press DOWN ARROW to display AUTO RETRACT on the screen.
3. Press ENTER to begin automatically retracting the jacks.
Manual Leveling Procedure
4. When the JACKS DOWN display goes o, press the power button on the Control Panel
to de-energize the system. After a brief visual inspection around the coach to verify the
jacks are all fully retracted, you may proceed to travel.
5. AUTO RETRACT can also be commenced by pressing and holding the RETRACT
button for 1 second.
In the event the jacks will not extend or retract there is a manual procedure where the jacks
can be overridden with the use of a hex wrench. For specic instructions on the override
procedure refer to the manufacturer’s owner’s manual found in your warranty packet.
If the ignition is in the “RUN” position, jacks are down, and the operator releases the parking
brake, all indicator lights will ash and the alarm will activate. The system will then auto-
matically retract the jacks until the jacks are fully retracted or the operator resets the parking
brake. The power unit will also operate to keep the jacks retracted in the event the leveling
system loses pressure as the coach is being driven.
The Leveling System is designed to sound an alarm and illuminate the control panel in the
event of (2) possible scenarios:
A “RETRACT” hose leaks.
The pressure holding the jacks in the retracted position falls to approximately
1500 PSI.
If the alarm sounds and the control panel illuminates and ashes while driving the vehicle:
Immediately nd a place to pull vehicle o roadway.
Set the parking brake.
Inspect all jacks, hoses and valves for leaks
If no leaks are observed:
Turn the control panel ON by pressing the power button.
Press RETRACT ALL JACKS button
Wait until “JACKS DOWN” light and alarm turn o.
Inspect jacks. If jacks are retracted and no leaks are observed, vehicle can be
driven.
To Next Page
Loading...
