Jaytech 600N - Lock door setting; Half-open setting

- 10 -
2. Lock door setting
(Only when the lock door function is
available, the setting will proceed.
The “lock” key can not be matched)
NOTE – Later model openers
may have ‘S’ in place of ‘SET’,
‘C’ in place of ‘CODE’, ‘+’ in
Place of ‘UP’ and ‘-‘ in place of
‘DOWN’
3. Half-open setting
(Only when the half-open function is
available, the setting can proceed.
The half-open key on the transmitter
can not be matched)
NOTE – Later model openers
may have ‘S’ in place of ‘SET’,
‘C’ in place of ‘CODE’, ‘+’ in
Place of ‘UP’ and ‘-‘ in place of
‘DOWN’
Press and hold “SET” button for 3 seconds until the LED
flashes “1”. Press “UP” or “DOWN” button to increase or
decrease. Adjust the LED to flash “5”, press “SET” button
to enter lock door setting. The LED displays the current
setting.
Press “UP” button, the LED displays “1”, the lock door
function is on. Press “DOWN” button, the LED
displays”0”, the lock door function is off. Press “SET”
button to confirm, the opener returns to standby mode.
When the lock door function is on and the door is fully
closed, the opener will lock the door automatically. The
door can only be opened by a transmitter after unlocking
by the “lock” key(S2) on the transmitter. (If not unlocked
by the S2 button on the transmitter, the light will flash
twice when pressing the open key on the transmitter)
Press and hold “SET” button for 3 seconds until the LED
flashes “1”. Press “UP” or “DOWN” button to increase or
decrease. Adjust the LED to flash “6”. Press “SET”
button to enter half-open setting. The LED displays the
current setting.
Press “UP” or “DOWN” button to increase or decrease.
When the LED displays ”1”, the half-open height is 30cm.
When the LED displays “2”, the half-open height is 60cm.
When the LED displays “3”, the half-open height is 90cm.
When the LED displays “0”, the half-open function is off.
Press “SET” button to confirm, the opener returns to
standby mode.
If the half-open function is on, only when the door is fully
closed, the door can half-open using the “S1” key on the
transmitter. If the door is at another position, the “S1” key
will not work.