14.TESTING THE SAFETY REVERSE SYSTEM
The safety reverse system test is important.
The garage door must reverse on contact with a 40 mm obstacle laid flat on the floor.
Failure to properly adjust the
opener may result in serious
personal injury from a closing
garage door.
Operate the door in the down
direction. The door must reverse
upon contact with the obstacle. If the
door stops on the obstacle, remove
obstacle and repeat limit and force
setting (refer section 13.3).
Repeat test of the safety reverse system.
15.FIXING WARNING LABELS
Once you have completed your installation and
successfully carried out the safety reverse
system test (outlined above), install the warning
labels provided with your opener as shown.
The WARNING label must be installed in a
prominent place near any fixed control.
Any fixed wall control or wireless door control
must be mounted at a height of no less than 1.5
m out of the reach of children.
Read the safety instructions (page 1) for further
details concerning safety.
To Next Page
Loading...