JB INDUSTRIES ELIMINATOR

Questions and Answers

C
cookvanessaJul 28, 2025
How to troubleshoot if my JB INDUSTRIES ELIMINATOR Water Pump won't start?
- N
  Nichole MorenoJul 28, 2025
  If your JB INDUSTRIES Water Pump won't start, first ensure the power cord is securely plugged in. Then, check that the motor switch is in the ON position. If the pump temperature is below 30°F, warm it up and then turn the motor switch on. Finally, ensure that the line voltage is within 10% of 115v.
C
chelseapowersAug 2, 2025
Why is my JB INDUSTRIES ELIMINATOR Water Pump not pulling a deep vacuum?
- M
  michelletuckerAug 2, 2025
  If your JB INDUSTRIES Water Pump isn’t pulling a deep vacuum, several issues could be the cause. Start by changing the oil if it's contaminated, or add oil if the oil level is too low. Check for air leaks in the system and repair them. Also, inspect the pump inlet fittings, clean or replace the o-ring. Finally, make sure to tighten the coupler set screws to the flats of the cartridge and motor if the coupler is slipping.
T
Tracy PadillaAug 9, 2025
What to do if my JB INDUSTRIES ELIMINATOR shuts down and will not start?
- J
  James LopezAug 9, 2025
  If your JB INDUSTRIES Water Pump shuts down and won't restart, the thermal overload may be open. To resolve this: 1. Disconnect the pump from the system. 2. Wait about 15 minutes for the motor to cool down. 3. Turn the pump back on. If it shuts down again, it needs repair.
J
jennifer37Aug 14, 2025
Why is oil dripping from the shaft of my JB INDUSTRIES ELIMINATOR?
- L
  leeandreaAug 14, 2025
  If oil drips from where the shaft enters the pump housing of your JB INDUSTRIES Water Pump, it indicates a damaged shaft seal. The solution is to replace the shaft seal.
E
Edward TurnerAug 21, 2025
What to do if JB INDUSTRIES ELIMINATOR Water Pump cycles on and off from a completely cold start?
- S
  Sandra WhiteAug 21, 2025
  If your JB INDUSTRIES Water Pump cycles on and off from a cold start before running smoothly, it could be due to oil backed up in the cartridge. Remove the 1/4" cap to clear it out. It might also be caused by improper shutdown of the pump; in this case, turn the pump on.

Summary

Introduction and Specifications

Motor Specifications

Details on motor power, voltage, RPM, and intake port for various ELIMINATOR pump models.

Pump Maintenance Procedures

Guidelines for adding, changing, and flushing oil in ELIMINATOR vacuum pumps for optimal performance.

Pump Operation

Instructions for safe start-up and shutdown procedures to prevent oil-related issues.

Repair Parts Identification

ELIMINATOR Series Repair Parts

Catalog of replacement parts for ELIMINATOR pumps with part numbers and descriptions.

Troubleshooting and Support

Troubleshooting Common Issues

Identifies symptoms, possible causes, and corrective actions for pump malfunctions.

Return for Repair Process

Procedure and contact information for obtaining a Return Goods Authorization (RGA) number.

Warranty Information

Details on the two-year warranty for ELIMINATOR pumps and conditions that may void it.

Available Accessories

List of accessories for ELIMINATOR pumps, including gauges, oil, filters, and couplers.