[Show Settings > Show Chase]
Used to select the installation position of the projector while used in standalone mode.
• Press the [MENU] button to access the different functions in the menu.
• Press the ▲/▼ buttons until the desired function is showing on the display.
• Press the [ENTER] button to select the desired show mode.
• [show 1]
• [show 2]
• [show 3]
• [show 4]
• Once the right mode is shown on the display, press the [ENTER] button to confirm.
[Show Settings > Slave Mode]
• Used to make the slave unit work in opposite to the master or to work in complete sync.
• Press the [MENU] button to access the different functions in the menu.
• Press the ▲/▼ buttons until the desired function is showing on the display.
• Press the [ENTER] button: the values can be changed
• Use ▲/▼ buttons to select the desired mode:
• Slave 1: the slave operates in complete sync with the master.
• Slave 2: the slave operates in the opposite mode as compared with the master.
• Once the correct option shows on the display, press the [ENTER] button to confirm.
[Show Settings > Sound Trigger]
• Used to make the unit work in audio mode .
• Press the [MENU] button to access the different functions in the menu.
• Press the ▲/▼ buttons until the desired function is showing on the display.
• Press the [ENTER] button: the values can be changed
• Use ▲/▼ buttons to select the desired mode:
[Show Settings > Sound Sense]
• Used to adjust the sensitivity of the build in microphone .
• Press the [MENU] button to access the different functions in the menu.
• Press the ▲/▼ buttons until the desired function is showing on the display.
• Press the [ENTER] button: the values can be changed
• Use the ▼/▲ buttons to choose a value between “000” (very low sensitivity) and “100” (high sensitivity).
• Press the [ENTER] button to confirm the desired sensitivity.
[Fixture Settings > Pan Inverse]
Used to select if the PAN movements are inverted or not.
• Press the [MENU] button to access the different functions in the menu.
• Press the ▲/▼ buttons until the desired function is showing on the display.
• Press the [ENTER] button: the values can be changed
• Use ▲/▼ buttons to toggle between [No] and [Yes].
• Press the [ENTER] button to confirm.
[Fixture Settings > Tilt Inverse]
Used to select if the TILT movements are inverted or not.
• Press the [MENU] button to access the different functions in the menu.
• Press the ▲/▼ buttons until the desired function is showing on the display.
• Press the [ENTER] button: the values can be changed
• Use ▲/▼ buttons to toggle between [No] and [Yes].
• Press the [ENTER] button to confirm.
[Fixture Settings > P/T Feedback]
• This function corrects the PAN/TILT positions automatically if someone bumps onto the machine.
• Press the [MENU] button to access the different functions in the menu.
• Press the ▲/▼ buttons until the desired function is showing on the display.
• Press the [ENTER] button: the values can be changed
To Next Page
Loading...
