FREE WHEEL MODE
In order to have a care giver push the power wheelchair, it must be put in Free Wheel
Mode. This mode disengages the drive mechanism to the wheels, making them free to push
manually. We recommend that you turn off the power of wheelchair when in this mode, both
for safety and to save battery power.
To put the D09 / D09B / D09C / D09D / D09E in Free Wheel Mode, come to a full
stop and turn OFF the power on the controller.
Push down on the two red levers located on each motor as shown
1.
2.
TRANSPORTING D09
To transport your D09 / D09B / D09C / D09D / D09E Wheelchair, it is advised that you
fold it up following the procedures below.
Turn OFF the power from the controller.
Remove seat cushion.
Press down the backrest and flip the back safety latch down to unlock the frame.
1.
2.
3.
Never transport the power wheelchair in a tie up system (electric mode), as the
D09 / D09B / D09C / D09D / D09E Power Wheelchair is not compatible with them.
Never sit in the wheelchair and be transported in moving vehicle. Do not place the
folded power wheelchair in the front seat with driver where it could move and slide.
Note
25
Photo 22. Push Down Two Red Levers on Each Motor.
To Next Page
Loading...
