Need help?Do you have a question about the JBL Basspro Nano and is the answer not in the manual?
General| Certification | CE |
|---|---|
| On/off switch | Yes |
| Product color | Black |
| Product type | Pre-loaded subwoofer |
| Subwoofer type | Active subwoofer |
| Subwoofer sensitivity | 12 dB |
| Subwoofer driver diameter | 152 mm |
| Subwoofer frequency range | 30 - 150 Hz |
| Subwoofer crossover frequencies | 50 - 150 Hz |
| Subwoofer driver diameter (imperial) | 6 \ |
| Subwoofer driver diaphragm material | Fiberglass |
Weight and Dimensions| Depth | 260 mm |
|---|---|
| Width | 195 mm |
| Height | 74.6 mm |
| Weight | 3530 g |
Adjusts input signal level to match source unit for optimal bass output, listening for distortion.
Selects the optimal phase setting for the most clean bass output from the woofer.
Filters out high-frequency information, ensuring only low frequencies are played by the woofer.
Enhances bass frequencies at 50Hz, allowing customization to user preference.
Checks power and ground connections when no audio is present and the power indicator is off.
Diagnoses DC voltage on amplifier output or low BATT+ voltage, suggesting service or charging system check.
Addresses amplifier fuse blowing due to incorrect wiring or a short circuit.
Relates distorted audio to GAIN settings or wiring, and lack of dynamics to input polarity/phase.
Solves engine noise by checking ground, adjusting GAIN, and rerouting cables away from power wires.
To Next Page
