Need help?Do you have a question about the JBL GTO 75.4 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| RMS Power at 4 Ohms | 75W x 4 |
| THD at Rated RMS Power | < 1% |
| Signal to Noise Ratio | > 80 dB |
| Crossover Frequency | 50 Hz - 200 Hz |
| Input Sensitivity | 200 mV - 4 V |
| Frequency Response | 10Hz |
| Bass Boost | 0 dB |
Details power output for 4-ohm and 2-ohm stereo/bridged configurations.
Specifies the noise level relative to the output signal.
Indicates the amplifier's ability to handle transient signals.
Safety precautions and general advice for installation.
Guidance on selecting and securing the amplifier's position.
Instructions for connecting the amplifier's power supply.
Guidance on connecting speakers to the amplifier.
Adjusting frequency filters for speaker output.
Calibrating the input signal level.
Pinout and representation of the KTC3198GR transistor.
Pinout and representation of the KTA1268GR transistor.
Pinout and representation of the KTC3200GR transistor.
Pinout and representation of the KTC3198BL transistor.
To Next Page
