To Next Page

To Previous Page

4. Connect the Mixer Module to the Speakers

On the back side of the mixer you will notice two ¼" phone jacks – these are your speaker output jacks.

Take the speaker cables and connect them from these jacks to the jacks on the back of the speakers.

5. Connecting the AC Power Cable

Connect the female end of the power cable to the mixer and plug the male end into the wall socket or

extension cord. Turn the "MASTER VOLUME" control to "0". Now turn the power switch to the "on" position.

You should see the "POWER" indicator illuminated. At this point you are ready to bring in an audio signal

and hear the signal amplied by the system.

To Left speaker

AC power inlet

To Right speaker

Questions and Answers:

Need help?

Do you have a question about the JBL Harman EON208P and is the answer not in the manual?

JBL Harman EON208P Specifications

General