Need help?Do you have a question about the JBL P80.4 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| RMS Power at 4 Ohms | 80 W x 4 |
| RMS Power at 2 Ohms | 120 W x 4 |
| Bridged RMS Power at 4 Ohms | 240 W x 2 |
| THD at Rated Power | <0.05% |
| Input Sensitivity | 200mV - 4V |
Connects left and right input channels using RCA plugs.
Connects speaker wiring to the amplifier's output connectors.
Contains two 20 Amp ATC type fuses for protection.
Provides connections for 12V+, GND, and REM power wires.
Adjusts input sensitivity for pre-amp and speaker level inputs.
Adjusts crossover frequency response when LPF/HPF switch is active.
Selects LPF, FLAT, or HPF frequency response modes.
Connects high-level speaker output signals to the amplifier.
List of Field Effect Transistors used in the amplifier.
List of Bipolar Junction Transistors used in the amplifier.
List of diodes, including rectifier, switching, and zener diodes.
List of various resistors with their values and types.
List of capacitors, including electrolytic, mylar, and ceramic types.
List of miscellaneous parts like thermistors, switches, and lamps.
List of components associated with the sub-PCB.
List of non-electronic parts like screws, heatsinks, and covers.
PWM IC diagram for controlling power supply and output.
Dual operational amplifier IC used in the audio circuitry.
Dual operational amplifier IC used in the audio circuitry.
To Next Page
