JBL SRX700 Series - Product Specifications; SRX712 M Specifications; SRX715 Specifications

SPECIFICATIONS
SRX712M - 12¨, two-way, bass-reflex, stage-monitor / utility
SRX715 - 15¨, two-way, bass-reflex (suspendable version, SRX715F)
Frequency Range (-10 dB): 70 Hz - 20 kHz
Frequency Response (±3 dB): 83 Hz - 18 kHz
Coverage Pattern: 90º x 50º nominal
Crossover Modes: Bi-amp / passive, externally switchable
Crossover Frequency: 1.2 kHz
Power Rating (Continuous¹/ Program/ Peak): Passive: 800 W / 1600 W / 3200 W
Bi-amp LF: 800 W / 1000 W / 3200 W
Bi-amp HF: 75 W / 150 W / 300 W
Maximum SPL²: 131 dB SPL peak
System Sensitivity (1w @ 1m): 96 dB SPL (passive mode)
LF Driver: 1 x JBL 2262H 305 mm (12 in) Differential Drive® woofer with neodymium-magnet and dual voice-coils
HF Driver: 1 x JBL 2431H 75 mm (3 in) voice-coil, neodymium-magnet compression driver
Nominal Impedance: Passive: 8 ohm
Bi-amp LF: 8 ohms
Bi-amp HF: 8 ohms
Active Tunings: dbx DriveRack, all models. Settings available at www.jblpro.com
Enclosure: Symmetrical stage monitor, 15 mm, 11-ply birch plywood.
Suspension / Mounting: Dual angle, 35 mm pole socket 2 x M10 fittings for optional SRX712M-YK yoke
Transport: Integrated handle / input cup
Finish: Black DuraFlex™ finish
Grille: Powder coated, black, 16-gauge perforated steel with acoustically transparent charcoal foam backing
Input Connectors: Neutrik ® Speakon® NL-4 (x2), one on each end
Dimensions (H x W x D): 349 mm x 546 mm x 260 mm (13.75 in x 21.5 in x 10.25 in)
Net Weight: 15 kg (33 lb)
Optional Accessories: SRX712M-CVR: Pull-over padded cover
SRX712M-YK: Suspension, mounting yoke
SS2-BK: tripod speaker stand
SS3-BK: satellite speaker pole, 35 mm diamter, 41 in (1041 mm)
Frequency Range (-10 dB): 43 Hz - 20 kHz
Frequency Response (±3 dB): 53 Hz - 20 kHz
Coverage Pattern: 75º x 50º nominal
Crossover Modes: Bi-amp / passive, externally switchable
Crossover Frequency: 1.2 kHz
Power Rating (Continuous¹/Program/Peak): Passive: 800 W / 1600 W / 3200 W
Bi-amp LF: 800 W / 1600 W / 3200 W
Bi-amp HF: 75 W / 150 W / 300 W
Maximum SPL²: 131 dB SPL peak
System Sensitivity (1w @ 1m): 96 dB SPL (passive mode)
LF Driver: 1 x JBL 2265H 380 mm (15 in) Differential Drive® woofer with neodymium-magnet and dual voice-coils
HF Driver: 1 x JBL 2431H 75 mm (3 in) voice-coil, neodymium-magnet compression driver
Nominal Impedance: Passive: 8 ohms
Bi-amp LF: 8 ohms
Bi-amp HF: 8 ohms
Active Tunings: dbx DriveRack, all models. Settings available at www.jblpro.com
Enclosure: Trapezoidal, 15 mm, 11-ply birch plywood
Suspension / Mounting: Dual-angle (0° or -10°) 35 mm pole socket
5 x suspension points, M10 or optional fly track kit (F version only)
Transport: 2 x steel handles
Finish: Black DuraFlex™ finish
Grille: Powder coated, black, 16-gauge perforated steel with acoustically transparent charcoal foam backing
Input Connectors: Neutrik® Speakon® NL-4 (x2)
Dimensions (H x W x D): 711 mm x 439 mm x 406 mm (28 in x 17.3 in x 16 in)
Net Weight: 22 kg (48 lb)
Optional Accessories: SRX715-CVR: Pull-over padded cover
SRX-FF3: Flying hardware kit (for use with F versions only)
229-00009-01: Suspension kit, includes 3 x 10 mm forged eyebolts & washers (for use with F versions only)
SS2-BK: tripod speaker stand
SS3-BK: satellite speaker pole, 35 mm diamter, 41 in (1041 mm)
¹ IEC filtered noise with 6 dB crest factor.
² Calculated based on peak power rating and sensitivity, 1 m.
4