EasyManuals Logo

JBL Studio 5 Series Manual

JBL Studio 5 Series
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
If, due to speaker placement or your room’s acoustics, you feel that the speakers produce a bit too
much bass output for your taste, you can use the provided port tube inserts to slightly reduce the
speakers’ output in the 50Hz – 100Hz region.
Insert the port tube insert about half way into the port tube opening as shown in the illustration. Be
careful not to push the insert through the port tube and into the speaker cabinet.
Note: The Studio 590 has two port tubes and includes two port tube inserts
Caring For Your speakers
Wipe the cabinet with a clean, dry cloth to remove dust. Damp cloth may dull the cabinet’s finish.
Do not use volatile liquids such as benzene, paint thinner or alcohol on the cabinet.
Do not spray insecticide near the cabinet.
To remove dust from the grille fabric, use a vacuum cleaner set to low suction.
Never apply suction or pressurized air to the horn opening.
Do not wash the grilles in water, as it may fade the color or make it uneven.
If the surfaces of the woofer cones become dusty, you can carefully sweep them clean with a soft,
dry calligraphy brush or paint brush. Do not use a damp cloth.
Specifications
Studio 590 Floor Standing Speaker
Speaker type: 2-1/2-way dual-woofer, floor standing
Low-frequency transducer: Two 8″ (200mm) Poly Plas™ cones with Symmetrical Field Geometry™
magnet structures, cast frames and rubber surrounds, magnetically shielded
High-frequency transducer: 1″ (25mm) compression driver with neodymium magnet and one-piece
Teonex ® diaphragm on a glass-filled ABS Bi-Radial ® horn, magnetically shielded
Recommended amplifier power: 250 watts
Frequency response: 35Hz – 40kHz (–6dB)
Nominal impedance: 6 ohms
Sensitivity (2.83V/1m): 92dB
Crossover frequencies: 1.5kHz
Enclosure type: Ported
Connector type: Dual gold-plated binding posts (bi-wire capable)
Available finishes: Black or cherry
Dimensions (H x W x D): 49-3/4″ x 12-11/16″ x 16-1/4″ (1263mm x 322mm x 413mm)
Weight: 69.5 lb (31.5kg)
Studio 580 Floor Standing Speaker
Speaker type: 2-way dual-woofer, floor standing

Other manuals for JBL Studio 5 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JBL Studio 5 Series and is the answer not in the manual?

JBL Studio 5 Series Specifications

General IconGeneral
BrandJBL
ModelStudio 5 Series
CategorySpeakers
LanguageEnglish

Related product manuals