REF. 54299
Outer wheel bearing installation
Select the largest pressure plate that best ts your bearing
and does not exceed its outer diameter.
Select the adapter sleeve that best ts your spindle bearing
housing.
Assemble components as shown in the drawing.
Hold the nut (G) while turning the pressure screw.
The pressure plate will push the bearing inside the bearing
housing.
An alternative installation method is as shown in the drawing
below:
Wheel hub installation
Select the smallest pressure plate that best ts and will apply
force to the inner bearing race.
Assemble components as shown in the drawing.
Hold the nut (G) while turning the pressure screw.
An alternative installation method is as shown in the drawing
below:
7
To Next Page
Loading...
