15 - Engine
18 - Engine Belt
03 - Drive Belt
15 - 96 9813/5050-2 15 - 96
Adjust
Adjustment is not possible with this drive belt. A
spring loaded tensioning unit ensures that the FEAD
(Front End Accessory Drive) belt is kept at the correct
tension.
Remove and Install
Remove
1. Make the machine safe. Refer to (PIL 01-03).
2. Stop the engine and let it cool down.
3. Use a socket of the specified size to locate
on to the hexagon spigot nut, carefully rotate
the tensioner against the spring force in the
direction shown. Do not use excessive force or
the tensioner will be damaged.
Dimension: 16mm
4. Keep holding the tensioner against the spring
force and lift the belt off the drive tensioner pulley.
5. Slowly release the spring force by rotating the
tensioner unit in the opposite direction.
To Next Page
Loading...
Need help?
General
