jcb 190T - Service Manual

SERVICE MANUAL
SKIDSTEER LOADER
135 [T4F], 150T [T4F], 155 [T4F],
175 [T4F], 190T [T4F],
205T [T4F], 210 [T4F], 215 [T4F]
EN - 9813/9750
ISSUE 1 - 05/2017
This manual contains original instructions, verified by
the manufacturer (or their authorized representative).
Copyright 2017 © JCB SERVICE
All rights reserved. No part of this publication may
be reproduced, stored in a retrieval system, or
transmitted in any form or by any other means,
electronic, mechanical, photocopying or otherwise,
without prior permission from JCB SERVICE.
www.jcb.com
Foreword
The Operator's Manual
You and others can be killed or seriously injured
if you operate or maintain the machine without
first studying the Operator's Manual. You must
understand and follow the instructions in the
Operator's Manual. If you do not understand
anything, ask your employer or JCB dealer to
explain it.
Do not operate the machine without an Operator's
Manual, or if there is anything on the machine you
do not understand.
Treat the Operator's Manual as part of the machine.
Keep it clean and in good condition. Replace the
Operator's Manual immediately if it is lost, damaged
or becomes unreadable.
Contents
01 - Machine
03 - Attachments, Couplings and Load
Handling
06 - Body and Framework
09 - Operator Station
12 - Heating, Ventilating and Air-
Conditioning (HVAC)
15 - Engine
18 - Fuel and Exhaust System
21 - Cooling System
24 - Brake System
27 - Driveline
30 - Hydraulic System
33 - Electrical System
72 - Fasteners and Fixings
75 - Consumable Products
78 - After Sales

jcb 190T Specifications

General

Brand	jcb
Model	190T
Category	Front End Loaders
Language	English

Summary

Foreword

The Operators Manual

Guidance on safe operation and maintenance of the machine using the Operator's Manual.

00 - General

Introduction

Explains the function of the bedplate as the main strength component of the engine.

Remove and Install

Details the steps for removing and installing components related to the engine bedplate.

15 - Engine

09 - Bedplate

Section detailing the engine bedplate, its components, and related procedures.

Technical Data

Table 39. Torque Values

Provides specific torque values for main bearing and peripheral bolts in Nm.

Operation

Lubrication

Describes how oil is fed to main bearings, big end bearings, and crankshaft gear.

Check (Condition)

Main bearing surfaces

Instructions to check main bearing surfaces for damage and excessive wear.

Calibrate

Axial clearance check

Procedure to measure crankshaft axial clearance using a dial gauge.

Dimensional Check

Crankshaft journals

Checking crankshaft journal and connecting rod diameters against service limits.