Section 2-1 - Care and Safety
Safety Notices
Safety Check List
2-1-10 2-1-10
9803/3750-05 (2-01-01)
!MWARNING
Scaffolding
Overloaded scaffolding can collapse. Never load
scaffolding beyond the regulation capacity.
5-1-4-6
!MCAUTION
Overhead Clearance
A raised boom can strike overhead objects. Always
check for overhead clearance before raising the boom.
5-1-5-1
!MWARNING
Boom/Travelling
Operating the boom while travelling can cause
accidents. You will not have total control of the
machine. Never operate the boom while travelling.
5-1-5-2
!MDANGER
Forks/Working Platform
Using the forks alone as a working platform is
hazardous; you can fall off and be killed or injured.
Never use the forks as a working platform.
5-1-5-3
!MWARNING
Forks/Turning
The forks extend beyond the end of the boom. Make
sure there is enough clearance for the forks when
making turns.
5-1-5-4
!MWARNING
Entering/Leaving
Entering or leaving the cab or canopy must only be
made where steps and handrails are provided. Always
face the machine when entering and leaving. Make
sure the step(s), handrails and your boot soles are
clean and dry. Do not jump from the machine. Do not
use the machine controls as handholds, use the
handrails.
INT-2-1-7_1
!MWARNING
Controls
You or others can be killed or seriously injured if you
operate the control levers from outside the machine.
Operate the control levers only when you are correctly
seated in the machine.
0179
!MWARNING
Powershift Transmission
Do not change from a high gear to a low gear (for
instance, 4th to 1st) in one sudden movement when
the machine is moving. Otherwise the machine will
rapidly decelerate, you or others could be killed or
seriously injured. When selecting lower gears, allow
the engine speed to drop before each gear change.
2-1-1-9_1
!MCAUTION
Passengers
Passengers in or on the machine can cause accidents.
Do not carry passengers.
INT-2-2-2_1
ProCarManuals.com
To Next Page
Loading...
