Section 2-2 - Care and Safety
General Procedures
Hydraulic Rams
2-2-17 2-2-17
9803/3750-05 (2-02-01)
a If parts other than genuine JCB parts are used,
the desired results may not be obtained. Use only
genuine JCB parts.
3 Caution during dismantling and reassembly.
a Dismantling the ram while it is still installed on the
machine can be dangerous as unexpected
movements of the machine can occur. Remove
the ram from the machine and then dismantle.
b If reassembled with dirty hands, foreign matter
can enter the ram causing a shorter life span and
also the other hydraulic equipment may be
damaged. Reassemble in a clean state.
c Follow the instructions in the diagrams regarding
torque tightening for screwed parts. If the torque
is too high or too low, it can cause damage.
ProCarManuals.com
To Next Page
