jcb 8045ZTS User Manual

Section 2 - Care and Safety
Safety Notices
Safety Check List
2-6 2-6
9803/9360-4
!MDANGER
Working Platform
Using the machine as a working platform is
hazardous; you can fall off and be killed or injured.
Never use the machine as a working platform.
5-1-5-9
!MWARNING
Machine Safety
Stop work at once if a fault develops. Abnormal
sounds and smells can be signs of trouble. Inspect
and repair before resuming work.
8-1-2-3
!MWARNING
Touching hot surfaces can burn skin. The engine and
machine components will be hot after the unit has
been running. Allow the engine and components to
cool before servicing the unit.
10-1-1-40
!MWARNING
Travelling at High Speeds
Travelling at high speeds can cause accidents. Do not
reverse in a high gear with full throttle. Always travel
at a safe speed to suit working conditions.
INT-5-3-3
!MWARNING
The engine has exposed rotating parts. Switch OFF the
engine before working in the engine compartment. Do
not use the machine with the engine cover open.
5-2-6-5
!MWARNING
You could be killed or seriously injured if you operate
a machine with a damaged or missing ROPS/FOPS. If
the Roll Over Protection Structure (ROPS)/Falling
Objects Protection Structure (FOPS) has been in an
accident, do not use the machine until the structure
has been renewed. Modifications and repairs that are
not approved by the manufacturer may be dangerous
and will invalidate the ROPS/FOPS certification.
INT-2-1-9_6
!MWARNING
Machines with a TOPS structure are equipped with a
seat belt. The TOPS structure is designed to give you
protection in an accident. If you do not wear the seat
belt you could be thrown off the machine and crushed.
You must wear a seat belt when using the machine.
Fasten the seat belt before starting the engine.
2-2-1-9
!MWARNING
Hillsides
Operating the machine on hillsides can be dangerous
if proper precautions are not taken. Ground
conditions can be changed by rain, snow, ice etc.
Check the site carefully. When applicable, keep all
attachments low to the ground.
8-1-1-1
!MWARNING
Visibility
Accidents can be caused by working in poor visibility.
Use your lights to improve visibility. Keep the road
lights, windows and mirrors clean.
Do not operate the machine if you cannot see clearly.
5-1-4-7
!MWARNING
Keep Your Hands and Feet Inside the Vehicle
When using the machine, keep your hands and feet
clear of moving parts. Keep your hands and feet within
the operator compartment while the vehicle is in
motion.
13-1-1-17
!MWARNING
Controls
You or others can be killed or seriously injured if you
operate the control levers from outside the machine.
Operate the control levers only when you are correctly
seated.
0179_2

jcb 8045ZTS Specifications

General

Brand	jcb
Model	8045ZTS
Category	Construction Equipment
Language	English