19
The machine is charged using the plug on the left hand side, as viewed from the entry side of the
machine. Once plugged in, green LED lights will start to flash on the charger, viewed through the
charger viewing window.
Note: Only use the original charger installed to the machine with the original batteries. Charge the battery
in a well ventilated place. Use an appropriate grounded industrial power supply with correct AC (alternating
current) input voltage to charge.
If at any time a fault occurs when charging, three battery charge LEDs will blink at the same time.
Refer to the operators handbook immediately.
A
B
A Charge Point
B Charger Viewing Window
Fig 9
Charge Level & Charging
To Next Page
Loading...
