Need help?Do you have a question about the jcb Access Series and is the answer not in the manual?
General| Brand | jcb |
|---|---|
| Model | Access Series |
| Category | Scissor Lifts |
| Language | English |
Describes machine type, height range, and power source.
Details intended use conditions, PPE, and operator qualifications.
Explains the naming convention and lists available models.
Explains the location of tie-down points and the importance of lock pins.
Details the procedure and safety for lifting by hoist.
Table providing X and Y axis distances for various models.
Describes safe forklift lifting procedures and slot locations.
Specifies temperature range and acceptable slopes.
Guides users to find machine-specific load capacity and wind ratings.
Identifies the machine's operating hours on the ground control panel.
Describes the toggle switch for platform raise/lower from ground controls.
Identifies the emergency stop button on the ground control panel.
Explains the key switch for selecting control modes (ground/platform).
Details controls for steering, horn, and speed selection on the platform.
Explains the joystick trigger used to enable machine operations.
Shows battery level and diagnostic fault codes on the platform controller.
Describes buttons for selecting lift/lower or drive modes.
Identifies the emergency stop button on the platform control console.
Identifies the lock and pump for releasing machine brakes.
Provides step-by-step instructions for safely releasing machine brakes.
Outlines the sequence for operating the machine from the ground.
Details the sequence for operating the machine from the platform.
Explains key switch position and notes on operating while charging.
Describes operation of the extending deck on the platform.
Explains the use of the power outlet in the basket.
Describes sensors monitoring machine angle and tilt.
Describes sensors for pressure detection and operational limits.
Explains the function of the pothole protection switch.
Explains the bar system for indicating battery charge level.
Details connecting the charger and expected LED indicators.
Explains LED patterns for charge status and faults.
Provides notes on charger usage, ventilation, and fault handling.
Identifies key parts within the hydraulic tray.
Identifies key parts within the battery tray.
Explains where diagnostic codes are displayed and their interpretation.
Lists fault codes for system, sensor, and switch issues.
Lists fault codes for drive systems, coils, and load warnings.
Lists fault codes for overload, tilt, and control issues.
To Next Page
