To Next Page

To Previous Page

ELECTRIC SCISSORS 23

Code Description Reaction Instructions

52 Drive forward coil fault Disable lifting and driving

Check no controls are

operated at start-up

53 Drive reverse coil fault Disable lifting and driving Contact JCB dealer

54 Lift up coil fault Disable lifting and driving Contact JCB dealer

55 Lift down coil fault Disable lifting and driving Contact JCB dealer

56 Right turn coil fault Disable lifting and driving Contact JCB dealer

57 Left turn coil fault Disable lifting and driving Contact JCB dealer

58 General brake coil fault Disable lifting and driving Contact JCB dealer

59 Parallel coil fault Disable lifting and driving Contact JCB dealer

60 Motor control wiring broken Disable lifting and driving Contact JCB dealer

61 MC eeprom fault Disable lifting and driving Restart the machine

62 MC mosfet short fault Disable lifting and driving Contact JCB dealer

64 MC wiring fault Disable lifting and driving Contact JCB dealer

68 Battery low voltage fault Disable all motion Check battery charge

69 MC throttle fault Disable lifting and driving Contact JCB dealer

70 MC main contactor coil short Disable lifting and driving Contact JCB dealer

71 MC main contactor weld fault Disable lifting and driving Restart the machine

72 MC main contactor driver fault Disable lifting and driving Contact JCB dealer

77 MC over temperature cut off Disable lifting and driving Contact JCB dealer

80 Over 80% load warning Warning only Check platform load

85 Pressure sensor 2 fault Disable all motion Contact JCB dealer

86 Down limit switch fault Disable all motion Restart the machine

87 Up limit switch fault Warning only Contact JCB dealer

90 Over 90% load warning Warning only Reduce weight in platform

99 Over 99% load warning Warning only Reduce weight in platform

OL Overloaded platform Disable all motion

Reduce weight in platform to

enable movement

LL Machine tilted beyond safe limits Disable lifting and driving Check the ground level

LF Up/down control fault Warning only Restart the machine

Diagnostic Codes

jcb Access Series User Manual

Questions and Answers: