Need help?Do you have a question about the jcb JCB-MS-210SB and is the answer not in the manual?
General| Blade Diameter | 210 mm |
|---|---|
| Blade Bore | 30 mm |
| No Load Speed | 5000 RPM |
| Max Cutting Depth at 90° | 70 mm |
| Power Source | Corded Electric |
Guidelines for safe operation, electrical precautions, and personal protective measures.
Instructions for proper tool usage, care, and safe handling practices.
Detailed safety instructions for operating the mitre saw and handling workpieces.
Defines the saw's purpose, highlights usage restrictions, and potential hazards.
Pre-operation checks and setup procedures to ensure safe use.
Instructions for attaching the saw, initial setup, and basic adjustments.
Setting the saw for precise 90° crosscuts and basic crosscut operation.
Procedure for performing crosscuts with the turntable set at 0 degrees.
Setting the saw for angled crosscuts and precise mitre cut adjustments.
Performing angled crosscuts with the turntable adjusted from 0° to 45°.
Guidance on performing mitre cuts with specific turntable and head angles.
Instructions for double mitre cuts and setting the maximum cutting depth.
Procedure for adjusting the cutting depth limiter screw.
Instructions for attaching the sawdust bag and safely changing the saw blade.
Step-by-step guide for safely replacing the saw blade.
Routine maintenance tasks, brush checks, and service information.
Guidelines for safe and compliant electrical hookup of the power tool.
Handling damaged cables, AC motor details, transport, and proper storage.
Instructions for safely transporting and storing the mitre saw.
To Next Page
