JCB-PW15040P
Instruction & User Manual
22
Soap Inlet
Soap Inlet Hose
Operation
Pressure Washing
IMPORTANT – When using pressure washer, don’t allow the
machine to idle for a long time. This will overheat the pump and cause
damage. If not using for extended periods of time, turn off the machine.
> With the Machine running with a constant water supply, Choose the nozzle best suited for your activity. Simply
pull the Lance Trigger and the machine will expel high pressure water.
> The trigger has an inbuilt Safety Lock Out. When not using the machine, to avoid accidental overspray, simply
extend the Safety Lock Out. There is a slot which the Lock Out will sit within
Lance Safety Trigger
Pressure Adjustment & Soap Function
> Place the Soap inlet, and inlet hose into your container with soap. Follow mix instructions supplied by the
manufacturer of the soap. If no instructions, assume it requires no mixing.
> The Soap inlet will draw the detergent through the hose into the pump, passing it through the lance. Some
aftermarket brands make Soap Bottles which are compatible with the Lance. If you wish to use one of these,
there isn’t any benefit to additionally drawing soap through the pump as shown.
> Adjust Pressure using Pressure Regulating Valve
Safety Lock Out
Location Slot
Pump Pressure
Regulating Valve
To Next Page
Loading...
Need help?
General
