34 - 25
Diverter Valve
Dismantling
1 Remove cover plug 1.
2 Remove ‘O’-ring 2 and discard.
3 Using a steel rod X with one end threaded M5 x 0.8,
screw into sleeve 3 and withdraw from control valve
body.
4 Remove ‘O’-ring 4 and discard.
Cleaning, Inspection
1 Clean all parts with clean oil and dry with compressed
air. Inspect all parts.
2 Ensure sleeve 3 moves smoothly.
3 Remove slight defects by lapping.
4 Renew damaged or badly worn parts.
Assembly
Assembly is the reverse of the dismantling procedure.
Torque Settings
1 29.8 Nm (22 lbf ft)
Section E Hydraulics
9803/6410
Section E
34 - 25
Issue 1
Control Valve
JS01450
To Next Page
Loading...
