Bucket Ram - Removal (cont’d)
8 Attach a sling to support the ram.
9 Remove the nuts and bolts from the cylinder end of the
ram. Push out the pin using a bar and hammer. Lift the
ram clear.
!!
WARNING
Metal Splinters
You can be injured by flying metal splinters when driving
metal pins in or out. Use a soft faced hammer or drift to
remove and fit metal pins. Always wear safety glasses.
INT-3-1-3
Bucket Ram - Replacement
1 Attach a sling to the ram and lift it into position on the
dipper.
2 Install the pin, bolt and nuts to the cylinder end of the
ram.
72 - 3
Section E Hydraulics
9803/6410
Section E
72 - 3
Issue 1
Hydraulic Rams
To Next Page
Loading...
Need help?
General
