27 - 1
Suction Strainer
!!
WARNING
Make the machine safe before working underneath it.
Park the machine on level ground, lower the boom.
Apply the parking brake, put the transmission in neutral
and stop the engine. Chock both sides of all four wheels.
Disconnect the battery, to prevent the engine being
started while you are beneath the machine.
GEN-003
Removal and Replacement
1 Remove the tank filler cap and unscrew plug A to drain
the tank.
Note: Always drain into a suitable container.
2 Unscrew bolts B, remove cover plate C together with its
gasket.
3 Unscrew and remove the main suction strainer, which is
screwed into a bulkhead connector inside the tank.
Wash in a suitable solvent and allow to dry.
Note: A new strainer should be similarly washed before
fitting, to remove the protective coating.
4 Reassemble in reverse order using a new gasket coated
with Red Hermetite. Refill the tank with the correct fluid
(see page 3/1 - 1).
Section E
Hydraulics
9803/8500
Section E
27 - 1
Issue 2
Hydraulic Tank
168141
BB
CC
AA
To Next Page
Loading...
