7 - 3
Electrics (cont'd)
Changing the Light Bulbs
Worklight Bulb
1 Support the light unit B remove screws A.
2 Lift and turn light unit B to gain access to connectors C
and D.
3 Disconnect at C and D.
4 Remove the bulb by releasing clips E.
5 Do not touch the new bulb with bare fingers. Fit the
new bulb.
6 Reassemble the light unit in the reverse order.
Cab Interior Light Bulb
1 Carefully lever light unit F from the roof, using a
screwdriver in the slot at one end.
2 Ease the spring contact G to release the bulb.
3 Fit new bulb. Make sure the bulb is seated in the spring
contact holes.
4 Refit light unit F, take care not to trap the wires.
Rotating Beacon Bulb
1 Remove the three screws H and remove cover J.
2 Release spring clip K and ease the bulb from its holder
L.
3 Disconnect the bulb at M.
4 Do not touch the bulb with bare fingers. Fit the new
bulb. Make sure that the bulb is seated correctly and the
spring clip K is secure.
5 Reassemble the light unit in the reverse order.
Section 3
Routine Maintenance
9803/8500
Section 3
7 - 3
Issue 1
133010
132930
132970
AA
AA
BB
CC
DD
EE
FF
GG
JJ
HH
HH
KK
LL
MM
To Next Page
Loading...
