10 - 1A
Engine
Air Filter from machine number 678000
Changing the Elements - for interval see Service Schedule
!!
CAUTION
The outer element must be renewed immediately if the
warning light on the instrument panel illuminates.
2-3-3-1
!!
CAUTION
Do not run the engine when the outer element has been
removed.
16-3-3-1
1 Stop the engine.
2 Gain access to the engine compartment by opening the
compartment rear door.
Open the hinged top cover
3 Depress clips A and lift off cover B. Remove outer
element C. Take care not to tap or knock the element. If
the inner element is to be changed, lift up pulls D and
remove inner element E.
4 Clean inside the canister G, cover B and dust valve H.
5 Insert the new elements into the canister, pushing them
firmly in so that seals F and J are fully seated. Fit cover
B with dust valve H at the bottom. Push the cover firmly
into position and make sure it is secured by clips A.
6 Make sure that the wire is connected to the Air Filter
Blocked switch.
Note: Do not attempt to wash or clean the elements - they
must only be renewed.
Note: Do not run the engine with the dust valve H removed.
Note: A new inner element must be fitted at least every third
time the outer element is changed. As a reminder, mark the
inner element with a felt tipped pen each time the outer
element is changed.
Section 3
Routine Maintenance
9803/8500
Section 3
10 - 1A
Issue 1
GG
FF
JJ
EE
CC
DD
BB
HH
AA
HH
BB
S257920
To Next Page
Loading...
