10 - 2
Engine (cont'd)
Checking the Oil Level - Peugeot XUD engine
- for interval see Service Schedule
!!
WARNING
Hot oil and engine components can burn you. Make sure
the engine is cool before doing this job.
2-3-3-2
1 Park the machine on level ground and lower the
attachments to the ground.
2 Stop the engine and remove the starter key.
3 Open the engine compartment rear door and hinged top
cover.
4 Check that the oil level is between the two marks on the
dipstick A.
5 If necessary, add the recommended oil through the filler
point B.
6 Make sure the filler cap and the dipstick are secure.
7 Close and secure the engine compartment hinged top
cover and rear door.
Changing the Oil and Filter - Peugeot XUD engine
- for interval see Service Schedule
!!
WARNING
Hot oil and engine components can burn you. Make sure
the engine is cool before doing this job.
2-3-3-2
This machine can be fitted with an engine oil drain plug kit.
This allows the oil to be safely changed when hot. No special
tools are needed.
1 Do Steps 1 to 2 of Checking the Oil Level.
Note: If a blanking plug is fitted, allow the oil sufficient time to
cool down.
2 Open the engine compartment rear door and top cover .
3 Access to the sump drain plug is through a centre line
blanking plate C. Remove the blanking plate and place a
suitable container beneath the machine to catch the oil.
4 Either remove drain plug to allow oil to flow into the
container or remove dust cap D and, with the free end of
the clear plastic hose in the oil receptacle, screw on the
drain coupling E and clear plastic hose F. This
automatically opens the valve, allowing the oil to flow
into the container.
Note: The drain coupling needs to be only hand tight.
Section 3
Routine Maintenance
9803/8500
Section 3
10 - 2
Issue 2*
174280
199450
193480
AA
BB
CC
DD
EE
FF
*
*
*
To Next Page
Loading...
