10 - 3
Engine (cont'd)
Changing the Oil and Filter - Peugeot engine (cont'd)
5 After emptying the sump, unscrew drain coupling E and
replace the dust cap D.
Note: The valve closes automatically as the coupling is
removed. The dust cap need only be hand tight.
6 Unscrew the filter canister G, using a chain wrench if
necessary. Remember that it will contain some oil.
7 Clean filter head H.
8 Add clean engine oil to the new filter canister. Allow time
for the oil to pass through the filter element.
9 Smear the seal J on the new filter canister with clean
engine oil.
10 Screw in the new filter canister - hand tight only.
11 Fill the engine with the recommended oil, to the MAX
mark on the dipstick A, through the filler point B. Wipe off
any spilt oil, refit the filler cap and make sure it is secure.
12 Make sure the engine will not start by removing the
engine shut-off solenoid (ESOS) fuse. Turn the engine
using the starter key until the oil pressure warning light is
extinguished.
13 Refit the engine shut-off solenoid fuse and start the
engine. Check for leaks. When the engine has cooled,
check the oil level and, if necessary, top up with clean
engine oil.
14 Close and secure the engine compartment rear door and
hinged top cover.
Section 3
Routine Maintenance
9803/8500
Section 3
10 - 3
Issue 3*
174310
HH
JJ
GG
*
To Next Page
Loading...
