5 - 2
Removal and Replacement
Peugeot Engines
Disconnect the battery negative lead.
Disconnect the cables to the main terminal A and solenoid
terminal B. Unscrew securing bolts C (3 off) and withdraw the
starter.
Replacement is a reversal of the removal procedure.
Torque Settings
Securing bolts C 34 Nm (25 lbf ft, 3.5 kgf m).
Service Procedures
Servicing this equipment is not recommended. Should faults
occur then the starter motor should be changed for a Service
Replacement.
Removal and Replacement
JCB Diesel Engines
See Engine Workshop Manual (JCB part no. 9806/2100) for
Removal, Replacement and Servicing procedures.
Section C
Electrics
9803/8500
Section C
5 - 2
Issue 3*
Starter Motor
250260
CC
AA
BB
CC
CC
*
To Next Page
Loading...
