*
23 - 1
Lift and Compensating Rams
Removal and Replacement
!!
WARNING
Make the machine safe before getting beneath it. Park
the machine on level ground. Make sure the engine is
stopped, the parking brake is engaged and the
transmission is in neutral. Disconnect the battery. Chock
all four wheels.
5-3-2-1
!!
WARNING
Lifting Equipment
You can be injured if you use faulty lifting equipment.
Make sure that lifting equipment is in good condition.
Make sure that lifting tackle complies with all local
regulations and is suitable for the job. Make sure that
lifting equipment is strong enough for the job.
INT-1-3-7
Proceed as described on page B/5 - 2 (Loader Arm
Removal) up to, but not including, the point at which the
loader arm pivot pins are removed. Disconnect the lift ram
(and/or the compensating ram) at A (B) as described in that
procedure.
Remove the rear pivot pin C (D) as appropriate. Lift the ram
clear of the machine. If a ram is to be off the machine for
sometime, or stripped for examination, take to a clean dry
area.
Replacement is a reversal of the removal procedure. Grease
all pins and securing bolts with JCB Special MPL Grease.
Torque securing bolts to 56 Nm (5.7 kg fm, 42 lbf ft).
!!
WARNING
Hydraulic Pressure
It is not possible to vent all residual pressure. Loosen the
connection one full turn and allow the pressure to
dissipate. Keep face and hands well clear of pressurised
hydraulic oil and wear protective glasses.
HYD 4-3
Section E
Hydraulics
9803/8500
Section E
23 - 1
Issue 2*
Rams
167770
To Next Page
Loading...
