Page 12 of 24
6. Launch Test App Launch test application as follows:
• For Layer 2 Electrical (Copper/RJ-45) Testing, press the ETH
ELEC Soft key, select Terminate, and press the OK key. Select
Layer 2 Traffic at the Test prompt
• For Layer 2 Optical Testing, press the ETH OPTIC Soft key, select
1G Terminate, and press the OK key. Select Layer 2 Traffic at the
Test prompt
• For Layer 3 IPv4 Electrical (Copper) Testing, press the ETH ELEC
Soft key, select Terminate, and press the OK key. Select Layer 3 IP
Traffic at the Test prompt
• For Layer 3 IPv4 Optical Testing, press the ETH OPTIC Soft key,
select 1G Terminate, and press the OK key. Select Layer 3 IP
Traffic at the Test prompt.
Technical Support tac@jdsu.com 855-275-5378
To Next Page
Loading...
