Page 14 of 24
12. Check LED Results Press the Right Arrow key until LED Results are displayed. A Green
Signal Present LED indicates that the HST-3000 is receiving an optical
signal from the near end Ethernet Switch. Green Sync Acquired and
Link Active LEDs indicate that the HST-3000 has successfully
connected to the near end Ethernet switch and the Ethernet link is active.
13. Check ARP Status If you are running a Layer 3 IPv4 Test, verify that the final message in
the Message bar is “ARP Successful”
If “ARP Successful” is not displayed, verify that the HST-3000’s IP
menu is configured correctly, as outlined above.
14. Test Inform the A-side technician that you are ready for test.
Technical Support tac@jdsu.com 855-275-5378
To Next Page
Loading...
