Page 17 of 24
10. Check LEDs Press the Restart soft key on the Right side of the display to reset test
results. A Green Signal Present LED indicates that the T-BERD is
receiving an optical signal from the near end Ethernet Switch. Green
Sync Acquired and Link Active LEDs indicate that the T-BERD has
successfully connected to the near end Ethernet switch and the Ethernet
link is active.
11. Check AutoNeg Stats For Copper (RJ-45) connections, if Auto Negotiation was enabled in the
Interface Setup, Set the right Results Group/Category to
Ethernet/Autoneg Status. Verify that Link Config ACK = Yes and
Duplex = Full.
12. Check ARP Status If you are running a Layer 3 IPv4 Test, verify that the final message in
the Message bar is “ARP Successful. Destination MAC obtained.” If
the message bar displays: “Messages logged,” tap the down arrow next
to “Messages logged” and verify that the final message is “ARP
Successful. Destination MAC obtained.” Click OK to exit the log.
If “ARP Successful” is not displayed, verify that the T-BERD’s IP menu
is configured correctly, as outlined above.
13. Test Inform the A-side technician that you are ready for test.
Technical Support tac@jdsu.com 855-275-5378
To Next Page
Loading...
