JDS Uniphase HST-3000 - Page 7

Page 7 of 24
7. Configure Test Press the Configure Navigation key to configure test setting. If you
have previously saved configuration files, press the Save soft key, then
Load Config and Load RFC 2544 Config. Follow prompts to load
desired files. Using the Right Arrow key or Settings soft key, scroll
through Settings menus and configure/update your test as follows.
Leave all other values at factory default settings, unless specified in the
Work Order.
For Layer 2 Testing:
For Layer 3 IP Testing:
RFC 2544 Settings:
RFC 2544
Settings
Load Format
Bit Rate
Length Type Frame Length
Option only displayed if
Test = Layer 3 IPv4
Customer
Enter Customer name
Technician
Enter Technician name
Location
Enter Location
Comments
Enter Comments
Test
Selections
Throughput
Enable
Latency (RTD)
Enable
Packet Jitter
Enable
System Recovery
Disable
Frame Loss
Enable
Back to Back
Disable
Maximum
Bandwidth
See Work Order for
Committed Information
Rate (CIR)
Menu
Option
Value
Comment
Test Mode
Test
Layer 2 Traffic
RFC 2544 Mode
Symmetric
SAM Complete
Disable
Link Init
Auto Negotiation See Work Order
Set to same values as
Ethernet switch port.
Speed
Set to 100 if Committed
Information Rate (CIR)
is less than 10 Mbps or
Auto Negotiation is Off;
Otherwise set to 1000.
Duplex
Full
Ethernet
Encapsulation
See Work Order
None or VLAN
VLAN ID
See Work Order
Menu
Option
Value
Comment
Test Mode
Test
Layer 3 IP Traffic
.
RFC 2544 Mode
Symmetric
Link Init
Auto Negotiation
See Work Order
Set to same values as
Ethernet switch port.
Speed
See Work Order
Duplex
Full
IP Init
ARP Mode
Enable
Source Type
Static IP
Source IP
See Work Order
Subnet Mask
See Work Order
Default Gateway
See Work Order
Menu
Option
Value
Comment
Technical Support tac@jdsu.com 855-275-5378