JDS Uniphase HST-3000 - Page 8

Page 8 of 24
Frame
Length
Frame 1
64 if no VLAN;
68 if VLAN
Frame 2
Disable
Frame 3
Disable
Frame 4
Disable
Frame 5
Disable
Frame 6
Disable
Frame 7
1518 if no VLAN;
1522 if VLAN
Frame 8 Disable
If the Maximum
Transmission Unit (MTU)
is greater than 1518 or 1522
w/ VLAN, enter MTU as
User Defined Length
Throughput
Accuracy
To within 1.0 (Mbps)
Trial Dur
60 sec
Frame Loss Tol.
0 Mbps
Show Pass/Fail
Yes
Threshold
See Work Order for CIR
Zero in Method
JDSU Enhanced
Latency
Number of Trials
1
Trial Dur
60
Show Pass/Fail
Yes for VoIP, IPTV,
Circuit Emulation, or
Cell Backhaul service;
No for other services
Latency Threshold
(µsec)
See Work Order
If not specified:
• 250,000 for VoIP
• 250,000 for IPTV
• 50,000 for Circuit
Emulation
• 20,000 for Mobile
Backhaul
Jitter
Number of Trials
1
Trial Dur
60
Show Pass/Fail
Status
Yes for VoIP, IPTV,
Circuit Emulation, or
Cell Backhaul service;
No for other services
Packet Jitter
Threshold (µs)
See Work Order
If not specified:
• 40,000 for VoIP
• 250,000 for IPTV
• 20,000 for Circuit
Emulation
• 3,000 for Mobile Backhaul
Setup,
Frame Loss
Test Procedure
RFC 2544
Trial Durations
(seconds)
60
Bandwidth
Granularity (%)
1Mbps
8. Save Config If your configuration file has not been previously saved, press the Save
soft key, select Save Config, enter a configuration file name, and press
OK. Press the Save soft key again, select Save RFC 2544 Config, enter
an RFC 2544 configuration file name, and press OK.
9. View Results Press the Home key to display Summary Results.
10. Turn Laser On For optical testing, press the Action soft key and select Laser On.
Menu
Option
Value
Comment
Technical Support tac@jdsu.com 855-275-5378