Jeanneau 64 - Bilge Pumps and Drainage

- 44 -
6.5.2 Bilge pumps and drainage
General points
- The inner moulding of the hull has channelling: the drainage channels. The drainage
channels allow the water to drain down to the lowest point in the boat, where it can be
discharged.. So it is important to allow the water to flow freely down to this lowest point of the
boat, which includes.
- Regularly cleaning the lowest point of the boat and the drainage channels.
Diagram of the layout - Bilge pumps
(*) 45 strokes/minute
If 70 stroke/minute: rate 105p/minute
Reference Designation Rate
1 Manual bilge pump 67p/minute (*)
2 Manual bilge pump lever
3 Electric bilge pump 91,5p/minute
3’ Electric bilge pump 53p/minute
4 Electric bilge pump switch