A
B
SINE Wave Technology
10min
_
+
FEED
DCW-5000
Can used different plug for power cord.
fig.2
Installation diagram:
Pump Cover
Rotor
O-Ring
BodyPump
Back Cover
DC Pump Controller
Rubber
Adaptor
SINE Wave Technology
10min
_
+
FEED
DCW-5000
Power Cord
MAINTENANCE
To clean the pump, remove the back cover, sealing cover and the impeller.
Use a small brush or stream of water to remove any debris.
If the pump not work, check as following:
Check the circuit. Please try to plug on another power socket, to ensure the pump
switched on with power. Note, please do not plug on before operation.
Check the pump outlet and tube, if blocked by dirty. Algae may block them, up i
can clean the algae using the pond water with a garden hose.
Check the inlet to ensure not clogged by debris.
Remove the pump inlet to access the impeller. Turn around the rotor to check if
Monthly maintenance will prolong your pump’s life..Clean the rotor, remove the
dirt. etc
NOTE: Ensure the electrical cord loops below the power socket like a “Drip
Loop”. It will prevent the water from running around the cable into the power
socket
Do not dispose this product as unsorted municipal waste. Collection of
such waste separately for special treatment is necessary. This product
must not be disposed together with the domestic waste. This product has
to be disposed at an authorized place for recycling of electrical and
electronic appliances. By collecting and recycling waste, you help save natural
resources, and make sure the product is disposed in an environmental friendly and
healthy way.
Jebao Co.,Ltd
Tongmao Industrical Park, Dongsheng, Zhongshan, Guangdong. China.
Email:info@jebao.com Website: www.jebao.com
Tel:+86-760-28136717/19/20
Fax:+86-760-28136725